Forum          FAQ

Loading

Board index » Dell Discussion and Support Forums » XPS 630i - Upgrade / Modification / Overclocking Discussion




 [ 1 post ] 
Author Message
 Post subject: BIOS Template Updated
 Post Posted: Wed May 20, 2009 6:46 am 
Offline
Tech Guru
Tech Guru
User avatar

Joined: Thu Jan 15, 2009 9:52 am
Posts: 1749
Location: Austin, Texas
Steam ID: fasterrhoads
It's hard for us to help out without knowing what your bios settings are. Fill this out if you are having a problem, so that we can look it over and save us time. Also, please put detailed hardware configurations in your signature including the timings and recommended voltages of your memory. Make sure you test your memory with two passes of memtest using a boot cd with each dimm in the first slot. Don't test them in pairs. When they pass, put them in the black slots.
Copy this template to a Word Doc. for future reference, then fill in the "Red Areas" and repost.

This template is for the 650i Motherboard

Fill In The Red Areas
1. Enter your BIOS by pressing F2 on startup.
2. Go to Advanced, and then CPU.
3. Enable the CPU Clock Ratio Unlock.
4. Disable C1E.
5. Disable SpeedStep.

BIOS Version: 1.0.*
**System **
CPU Freq, MHz: * GHZ
FSB Reference Clock, MHz: ****
CPU Multiplier: [*X]
PCle Bus, Slot 1, MHz: [100]
PCle Bus, Slot 2, MHz: [100]

**Overclock FSB & Memorv Config**
FSB - Memory Clock Mode: [unlinked]
FSB - Memory Ratio:
FSB (QDR), MHz: [****]
Actual FSB (QDR), MHz: ****
x MEM (DDR), MHz: ****
Actual MEM (DDR), MHz: ****

**Memory Timing Setting**
Memory Timing Setting: [manual]
tCL (CAS Latency): *
tRCD: *
tRP: *
tRAS: *
Command Per Clock: [*T]
** Advanced Memory Settings **
tRRD: [Auto]
tRC: [Auto]
tWR: [Auto]
tWTR: [Auto]
tFAW: [Auto]
tREF: [Auto]

**System Voltages**
CPU Core: [*]
CPU FSB: [*]
Memory: [*]
Chipset Voltage nForce SPP: [*]

**CPU Configuration**
C1E Function: [Disabled]
Execute Disable Bit: [Enabled]
Virtualization: [Disabled]
SpeedStep: [Disabled]
Frequency Unlimited: [Enabled]

EVGA and Other Non Dell Motherboards

BIOS Version: P0*
**System **
CPU Freq, MHz: * GHZ
FSB Reference Clock, MHz: ****
CPU Multiplier: [*X]
PCle x16-1 & 16-2, MHz: [100]
PCle x16-3, MHz: [100]
SPPc->MCP Ref Clock, MHz: [200]
nForce SPP --> nForce MCP: [5X]
nForce SPP c-- nForce MCP: [5X]
**Spread Spectrum**
CPU Spread Spectrum: [Disabled]
HT Spread Spectrum: [Disabled]
PCle Spread Spectrurn(SPP): [Disabled]
PCle Spread Spectrurn(MCP): [Disabled]
SATA Spread Spectrum: [Disabled]
**FSB & Memorv Config**
FSB - Memory Clock Mode: [unlinked]
FSB - Memory Ratio:
FSB (QDR), MHz: [****]
Actual FSB (QDR), MHz: ****
x MEM (DDR), MHz: ****
Actual MEM (DDR), MHz: ****
P1: [AUTO]
P2: [AUTO]
**Memory Timing Setting**
Memory Timing Setting: [manual]
tCL (CAS Latency): *
tRCD: *
tRP: *
tRAS: *
Command Per Clock: [*T]
** Advanced Memory Settings **
tRRD: [Auto]
tRC: [Auto]
tWR: [Auto]
tWTR: [Auto]
tFAW: [Auto]
tREF: [Auto]
**System Voltages**
CPU Core: [*]
CPU FSB: [*]
Memory: [*]
nForce SPP: [*]
nForce MCP: [*]
GTLVREF Lane 0: [Auto]
GTLVREF Lane 1: [Auto]
GTLVREF Lane 2: [Auto]
GTLVREF Lane 3: [Auto]
**CPU Configuration**
Limit CPUlD Maxval: Disabled
Intel Speedstep: Disabled
xPPM Mode: [Native]
CPU Thermal Control: [Disabled]
C1E Enhanced Halt State: [Disabled]
Execute Disable Bit: [Enabled]
Virtualization Technology: [Disabled]
CPU Core 0: [Enabled]
CPU Core 1: [Enabled]
CPU Core 2: [Enabled]
CPU Core 3: [Enabled]


X58 3 Way SLI & X58
Items that are for the X-58 3x only have a single * before tie line. Items that are for the X-58 Classified only have two ** before the line. When using this template please fill out the areas in ().

Frequency Control
CPU Clock Ratio ( 31X )
CPU Host Frequency (Mhz) ( 144 )
MCH Strap ( Auto )
CPU Uncore Frequency (Mhz) ( 4156Mhz { 29X } )
CPU Clock Skew ( 0 ps )
Spread Spectrum ( Disabled )
PCIE Frequency (Mhz) ( 101 )


Memory Feature
Memory Speed ( XMP Profile 1 )
Memory Control Setting ( Enabled )
Memory Frequency ( 1866Mhz / 2:14 )
Channel Interleave Setting ( 6 Way )
Rank Interleave Setting ( 4 Way )
Memory Low Gap ( Auto )
tCL Setting ( 7 )
tRCD Setting ( 8 )
tRP Setting ( 7 )
tRAS Setting ( 20 )
tRFC Setting ( 110 )
Command Rate ( 1t )


Voltage Control
EVGA VDroop Control ( Without VDroop )
CPU VCore ( 1.425 )
CPU VTT Voltage ( +350 )
CPU PLL VCore ( 1.350 )
**IOH PLL VCore ( 1.350 )
DIMM Voltage ( 1.65 )
DIMM DQ Vref ( +0mV )
QPI PLL VCore ( 1.425 )
IOH VCore ( Auto )
IOH/ICH I/O Voltage ( Auto )
**BR04 ( NF200) Voltage ( Auto ) (only on E-759)
**VTT PWM Frequency ( 610 KHZ )
**CPU PWM Frequency ( 1333 KHZ )
**CPU Impedance ( Less )
**QPI Signal Compensation ( Middle )
ICH VCore ( Auto )
*PWM Frequency ( Not Used on Classified )


CPU Feature
Intel SpeedStep ( Disabled )
Turbo Mode Function ( Enabled )
CxE Function ( Disabled )
Execute Disable Bit ( Disabled )
Virtualization Technology ( Disabled )
Intel HT Technology ( Enabled )
Active Processor Cores ( All )
QPI Control Settings ( Enabled )
QPI Link Fast Mode ( Enabled )
QPI Frequency Selection ( 6.400 GT/s )
OC Recorvery ( Enabled )

PnP/PCI PCI Express
Maximum Payload Size ( 128 )


EVGA 750i FTW Bios Template

BIOS Version: P0* SZ1K

**Advanced BIOS features**
-CPU Feature-
Thermal Mgmt [Disabled]
Intel speed step [Disabled]
xPPM mode-native mode
Limit CPUID MaxVal [Disabled]
C1E Function [Disabled]
Execute disable bit [Enabled] Disabled
Virtualization Tech [Enabled] Disabled

CPU core 0 [Enabled]
core 1 [Enabled]
core 2 [Enabled]
core 3 [Enabled]
APIC mode [Enabled]
MPS Version Control for O/S [1.4]

**Advanced Chipset features**
Spread Spectrum Control
-CPU Spread Spectrum [Disabled]
PCIE Spread Spectrum [Down Spread] Disabled
Sata Spread Spectrum [Disabled]
LDT Spread Spectrum [Disabled]
System BIOS cacheable [Disabled]

**Power Management Setup**
ACPI Function [Enabled]
ACPI Suspend type [S1 & S3]

**Frequency/Voltage Control**
- System Clocks
Frequency Setting Setting
Current CPU Freq, Mhz 2999.9
FSB clock, Mhz 1332.8
PCIE Freq, Mhz [100]
-FSB & Memory Configuration
CPU multiplier 9x
FSM-Mem clock mode [Unlinked] Auto
xFSB-Memory ratio [Auto]
FSB (QDR), Mhz [1333]
Actual FSB (QDR) 1332.8
Memory(DDR),Mhz [1066]
Actual memory(DDR) 1066.2

**Memory Timing Settings**
Mode [Expert]
tCL [5]
trcd [5]
tRP [5]
tRAS [15]
command/clock [2T]
-Advanced Memory timings-
tRRD [4] 1-15
tRL [29] 1-31
tWR [6] 1-6
tWTR [10] 1-15
tREF [7.8 us]

**System Voltages**
CPU core [1.375]
CPU FSB [1.15]
Memory [2.1]
NForce SPP [1.4]
NF200 [1.25]

GTLvref Lane0 [+.00mv]
Lane1 [+.00mv]
Lane2 [+.00mv]
Lane3 [+.00mv]

CPU fast read [Disabled]
CPU Clock ratio [9x]
CPU N/2 ratio [Enabled}
LDT frequency [5x]


BIOS Template for the 780i

BIOS Version: P0*
**System **
CPU Freq, MHz: * GHZ
FSB Reference Clock, MHz: ****
CPU Multiplier: [*X]
PCle x16-1 & 16-2, MHz: [100]
PCle x16-3, MHz: [100]
SPPc->MCP Ref Clock, MHz: [200]
nForce SPP --> nForce MCP: [5X]
nForce SPP c-- nForce MCP: [5X]
**Spread Spectrum**
CPU Spread Spectrum: [Disabled]
HT Spread Spectrum: [Disabled]
PCle Spread Spectrurn(SPP): [Disabled]
PCle Spread Spectrurn(MCP): [Disabled]
SATA Spread Spectrum: [Disabled]
**FSB & Memorv Config**
FSB - Memory Clock Mode: [unlinked]
FSB - Memory Ratio:
FSB (QDR), MHz: [****]
Actual FSB (QDR), MHz: ****
x MEM (DDR), MHz: ****
Actual MEM (DDR), MHz: ****
P1: [AUTO]
P2: [AUTO]
**Memory Timing Setting**
Memory Timing Setting: [manual]
tCL (CAS Latency): *
tRCD: *
tRP: *
tRAS: *
Command Per Clock: [*T]
** Advanced Memory Settings **
tRRD: [Auto]
tRC: [Auto]
tWR: [Auto]
tWTR: [Auto]
tFAW: [Auto]
tREF: [Auto]
tRFC:
**System Voltages**
CPU Core: [*]
CPU FSB: [*]
Memory: [*]
nForce SPP: [*]
nForce MCP: [*]
GTLVREF Lane 0: [Auto]
GTLVREF Lane 1: [Auto]
GTLVREF Lane 2: [Auto]
GTLVREF Lane 3: [Auto]
**CPU Configuration**
Limit CPUlD Maxval: Disabled
Intel Speedstep: Disabled
xPPM Mode: [Native]
CPU Thermal Control: [Disabled]
C1E Enhanced Halt State: [Disabled]
Execute Disable Bit: [Enabled]
Virtualization Technology: [Disabled]
CPU Core 0: [Enabled]
CPU Core 1: [Enabled]
CPU Core 2: [Enabled]
CPU Core 3: [Enabled]

_________________
Current:
New Case Coming: Intel Core i7 980-X @4.5GHz*EVGA X58 E770 Classified 3 Way*Corsair H100 4 Scythe Fans Push/Pull*Mushkin Redline 6GBs 1600Mhz*EVGA GTX 570SC*WD Velociraptor 600GB*Lamptron Fan Controller Touch*Enermax Galaxy EVO 1250W Sleeved*Windows 7 64Bit Ultimate*

New O.C. 5.13.11
Image


Previous CPU:
Image

BIOS Templates

Supported PhysX Games
Click Here


Top 
  
 
 
 [ 1 post ] 

Board index » Dell Discussion and Support Forums » XPS 630i - Upgrade / Modification / Overclocking Discussion


Who is online

Users browsing this forum: CommonCrawl [Bot], Exabot [Bot], Yahoo [Bot] and 0 guests

 
 

 
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: